- 850000.00 INR
- Railways And its suppliers ,Foundries , Automobile , Ship Yard & any Metal Base Industries for Surface Treatment & preparation
Machine to be made from 6 mm thick MS plate all sides, hopper below blast chamber and top.
01 Nos Blast wheel 15.50 x 2.50, bi-directional 10.0 HP, 2250 RPM Belt Driven type Wheel.
02 Nos Door will be provided with Swing Table and Drive Arrangement (Cantilever supported by standing fabricated boom).
Manganese steel lining to be provided in the direct blast zone chamber remaining area will be covered with 6 mm thick rubber lining.
All liners inside the direct blast zone chamber to be replaceable (bolted).
10 mm thickness Mn liners to be used.
Double Door Swing Table Shot Blasting Machine (Work Load Capacity 400 kgs.).
01 Nos of Blast Wheel Assy. Fitted on top of cabinet.
The Hopper will be covered with M.S. Perforated Sheet 10 mm Thick.
Soundabrator valve to muffle noise will be provided.
Machine will be supplied with Media Separation System.
All motors to be used of ABB/Bharat Bijli Makes only 415V/3Ph/50Hz .
All Bearings to be used of NBC/SKF/KKK/FK make.
Pneumatics will be provided of Janatics/Rotex/Airmax.
All electrical connections and wiring of the Panels will be properly crimped, routed, cased and will not be left loose.
All shafts, keyways, keys, bearings, fasteners to be metric size only.
Machine will be provided with one point pneumatic supply (Compressed Dry Air in buyer's scope). All pneumatic piping from point of supply to wherever air is required (Sound Abrator valve, shot adding device cylinder) will be AEPL scope. FRL unit to be supplied. Air supply to the dust collector shall be 1 pipe and separate from the machine.
Abrasive Separator and Elevator Assembly
Elevator head section to be made from 5 mm thick MS Sheet
Elevator boot section to be made from 5 mm thick MS Sheet
Elevator intermediate section to be made from 10 SWG sheet metal.
Abrasive separator section to be made from min 10 SWG sheet metal.
Shot hopper below abrasive separator unit to be made out of 10 SWG or reinforced in areas prone to wear by continuously falling shots if not made out of 10 SWG.
Removable tray to be provided in the separator at the point where buckets discharge shots into the separator for periodic cleaning.
Using dome nuts with spike bolt for mounting of buckets on the elevator conveyor.
We will provide 2 copies of operation and maintenance manuals will be required.
Diameter of swing table
Total Power required (HP)
Dust Collector Capacity (CFM)
Loading Height (mm)
Power of Blast Wheel (HP)
15.5" * 2.5"
Shot Flow Rate (Ton/Wheel/Hour)
- 10 Per Year
- 4 Week
- Middle East, Asia
- All India
Manufacturing Unit-I : G-192-A, M.I.A., Basni, Phase-II, Road No. 04,, Jodhpur, Rajasthan, 342005, India